Warmup heating cables are constant wattage cables that should be tested on a 200 ohm scale.
Floor temperature sensor resistance.
With the digital multimeter scale set at 20k ohms the ohms reading of the.
It can be used to measure air or floor temperature and is specifically designed to be used as a floor sensor.
The floor temperature sensor does not seem to be working properly.
The 3m remote sensor probe can be used with all of our thermostats that accept a remote sensor.
The floor sensor may be damaged or may not be in the proper location with the sensor tip placed halfway between heating wires.
Test 4 temperature sensor.
Look at the front of the engine block in the middle of the pulleys.
Always ensure resistance matches the information on the product tag.
Check the thermostat floor temperature sensor cable by disconnecting the floor sensor cable from the thermostat measure the sensor cable resistance in ohms using a digital multimeter.
Suitable for use in wet areas ip68.
Replacement floor temperature sensor suitable for a wide range of underfloor heating thermostats.
The resistance will vary according to the temperature i e the colder the sensor the higher the resistance.
Every comfortzone electric underfloor heating thermostat should be set up with a floor temperature sensor probe to monitor the temperature of your floor.
You will search for the sensor within the engine block itself using a drop light if you need help to see it better.
The thin casing allows for retrofit installation between tile spaces if necessary.
Pull the latch for the hood and open it making sure it is secure before letting go.
Test the floor temperature sensors using a multimeter to verify accuracy of the sensors.
Works with a wide range of different thermostatsplease check the resistance values of your current sensor against the table below for compatibility 3 metre long cable cable has high rigidity allowing it to be easily passed through existing flexible conduit suitable for use in wet areas.
This sensor is designed to provide a thermostat with the ability to maintain a minimum slab temperature or help to limit the maximum slab temperature.
Please check the resistance values of your current sensor against the table cable has high rigidity allowing it to be easily passed through existing flexible conduit.
3 meter floor temperature sensor probe for underfloor heating thermostat features works with a wide range of different thermostats.
To ensure that your floor heating system will function properly always test the resistance of your wires with a digital multimeter set to 200 ohms before during and after installation.
Try temporarily hooking up a new sensor to the control.
The coolant temperature sensor is located on the engine block under the hood.
Sensor wire should be between 7 000 ohms to 14 000 ohms.
