Using either a screwdriver or allen key loosen the set screw and remove the handle which will uncover the shaft.
Fix loose door handle screws.
By loosening the set screw with either an allen key or screwdriver you should be able to remove the handle and expose the shaft.
Release the tab or button remove the inside doorknob by locating the button like our model metal tab or wire clip on the side of the knob that acts as a release.
When dealing with a lever door handle fixing the problem will require only the most basic of tools and about 10 minutes of time.
The detent is a spring activated pin concealed or small thin plate attached to the spindle that protrudes into a doorknob notch which prevents rotation.
If exposed screws are being used you will have to find the set screw which is normally found on the inside of the door.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
This screw fits in a groove on the round lever rod.
If a doorknob loosely spins on the spindle the cause is usually that a set screw similar to a grub screw has loosened up and has lost its grip on the handle spindle.
To adjust the screw or allen key look around the collar on the doorknob to identify the loose screw and using the appropriate screwdriver tighten the screws.
This type is usually found on round doorknob hardware.
The set screw helps keep the handle in place when you rotate it to open the door.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
That s because modern door hardware uses a hidden mechanism called a detent to fasten the doorknob that can only be released using a small screwdriver tip or the end of a paper clip depending on your style of hardware.
This type is found commonly on lever style door handles.
A loose lever requires some readjustment to properly fit into the rod assembly.
If the shaft is threaded then twist the handle on the shaft until it is flush with the door.
Tighten a loose door handle photo 1.
Levers handles slide onto a rod assembly with a set screw.
Using an awl or small screwdriver push the button in all the way and at the same time pull off the handle.
However before you begin to do this you should take the time to adequately determine which type of door knob you have in place.
Once triggered the lever or lock trim can be removed from the door.
Straighten a paper clip and insert it into the hole.
