Finding Break In Invisible Fence With Am Radio

Check your fence instructions for the exact frequency.

Finding break in invisible fence with am radio.

The kit includes a mini transmitter and an am radio. Set the field width knob on the wall transmitter at the minimum level to obtain a signal on the portable radio. What you are doing here is making a diy wire locator using a lawnmower as a transmitter a wire to connect the transmitter to the underground cable and the am radio to find where the wire is located. Fourth use an am radio most types of fence use an am signal including if brand not a fm signal and walk the wire listening for the tone.

Based upon our extensive tests we have determined that this device only works well for fence systems with less than 500 feet of wire. This usually is an am frequency on the lower end of the spectrum. Turn off your dog fence transmitter. Connect your wire break locator to your twisted wire.

Do the same thing using the other wire. Hooking up to both fence wires will send a signal up both sides of the break making it much harder to detect. Save the 70 and make your own diy locator using an am radio. Now that the wire locator transmitter is hooked up and sending a signal with our fence unit we can use the wire locator receiver to find the break in your underground fence.

Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. Ground the sending unit by attaching the enclosed wire to the center screw of an electrical outlet. Unplug your dog fence transmitter. The wire breaks must be clean breaks.

Search the am stations until you have found the correct one. If the instructions are unavailable turn on a portable am radio near the fence transmitter. With close to 2000 of wire i started on the end that seemed the most vulnerable i found the break about 150 from the opposite end where the kids buried a dead bird. The hard part was finding an am fm radio got stuck walking around with a hulking desktop radio from target.

How to find break in invisible fence using an am radio. Turn on the am radio turning the station to 530 khz. Don t have a wire locator. This product is not effective for finding partial or decaying breaks.

Plug in the sending unit so that both lights on the transmitter are lit. Set a portable am radio to am 60 or am 600. Find the radio frequency that your invisible fence is using. Hold the radio chest high and swing the radio over the wire while walking around the boundary.